Water sticker is a new transfer printing technology.

The so-called water stickers, is actually a brand new transfer printing technology.General traditional printing or heat transfer or pad printing, for complex shape workpiece is helpless, and the special function of water transfer printing, not only easy to cope with this problem, and can be applied to different material, more because of design, colour and lustre is lively and raise the added value of the product.Its characteristic is:

(1) the bearing is stuck in any curve and curved surfaces, regardless of the pad printing can do it, it can be easily, can completely replace the pad printing.

(2) water stickers screen printing: bright color, ink layer thick products.Design picture subject sense is strong, is other printing method.

(3) water stickers offset printing: mainly used in network and gradient effect more complex patterns.

Edit this section of the application of industry (1) : automotive supplies all kinds of model car appearance design, instrument panel, control panel, tissue boxes, tea cups, tape, kinds of frames and manipulation of the handle, locks, etc;

(2) electronic products: phones, pagers, video recorders, TV sets, air conditioners, speakers, remote control, mouse, U disk, etc.;

(3) bedroom supplies: sofa, tea table, hutch ark, droplight, ashtrays, vases, decoration, container, etc.;

(4) daily products: glasses, glasses box, pen, pen holder, desk calendar, art frame, the racket, cosmetic box, etc.;(5) indoor building materials: doors and Windows, floor, sticking wallboard, etc..

Edit this paragraph process (1) the first tear to isolate paper and then the required pattern is cut out.Effect of the finished product

(2) into the room temperature water immersion, to the design of paper in water surface sliding so far (about 5-10 seconds).

(3) remove the post content required in bearing position in drag way, with a soft cloth or paper towel evenly to bubbles and water.

(4) fully dry, (about 4 hours), can also be placed in the oven roasted, about 30 minutes, the temperature of 75 degrees or so, the transfer is completed.

(5) if more on its surface spray a layer of light oil, regardless of any effect will be greatly improved.Do not spray can also but poor adhesion.